3
Installation
Before installing the appliance accessory, make sure all parts are present. Compare parts with the
package contents listed below. If any part is missing or damaged, do not attempt to assemble, install, or
operate the appliance. Contact customer service for replacement parts at 1-888-534-1578.
Package Contents:
Fig. 1—Grounded
Three-Prong Receptacle
WARNING
Electrical grounding instructions: This appliance is
equipped with a three-prong (grounding) plug for
your protection against shock hazard and should be plugged directly
into a properly grounded three-prong receptacle (See Fig. 1).
Disconnect heater from the gas supply before installing the fan
accessory. Contact a qualified service person to do this.
1. Remove the blower panel using a screwdriver (see Fig. 2).
Fig. 2—Remove Blower Panel
Fig. 3—Attach Blower Duct
2. Attach blower duct to the rear panel of the heater
using three screws provided (see Fig. 3).
Complete blower accessory
•
Blower duct
•
Wire harness
•
ON, OFF and AUTO switch
•
To Next Page
Loading...
