Need help?Do you have a question about the Heathkit HA-10 and is the answer not in the manual?
Configuration of the four 811A tubes used as input and driver amplifiers.
Component C9 used for neutralization in the amplifier stages.
Configuration of the two 866A tubes acting as the final amplifier output.
Inductor L2 serving as a filament choke for the amplifier tubes.
Rotary switch for selecting different frequency bands.
Capacitor C10 used for tuning the amplifier circuit.
Rotary switch for selecting various meter functions.
Potentiometer R12 for adjusting relative power sensitivity.
Components related to the high-voltage power supply rectification and filtering.
Output network including inductors L3 and L4 for impedance matching.
Important notes regarding switch positions and component details.
Notes specifying resistor and capacitor value conventions.
General
