Need help?Do you have a question about the Heathkit HL-2200 and is the answer not in the manual?
General| Input Impedance | 50 ohms |
|---|---|
| Output Impedance | 50 ohms |
| Mode | SSB, CW |
| Input Power | Approximately 100 watts for full output |
| Tube Complement | Two 3-500Z |
| Power Requirements | 240V AC, 50/60 Hz |
Instructions and pictorials for assembling the main circuit board.
Guides on preparing and connecting wires to the circuit board.
Details on assembling the input coil unit.
Instructions for assembling the rotary switch unit.
Steps for mounting components and controls on the front panel.
Mounting various parts and hardware onto the chassis.
Procedure for checking resistance values as part of final testing.
A chart correlating common problems with their possible causes.
To Next Page
