Heathkit IB-5281 - Page 29

age 27
|
Ge
gurstTHxit:
.
lf
A MALE
CONNECTOR
PIN
Se CRIMP AND
Wada - SOLDER
( >) FEMALE
CONNECTOR
\ey SHELL
ZL
mK ea
NZ 3
rls 1 & A
1-3/4"
SS
Detail 3-6A
1 Slide switch (#60-2).
1 Mounting plate (#92-669).
3 Male connector pins (#432-72).
1 Connector shell with ears (#432-720). +
2 6-32 X 1/4" screw (#250-56).
Refer to Pictorial 3-6 (Illustration Booklet, Page 4) for
the following steps.
( ) Prepare the following wires:
1-3/4" red
7” black
2-1/4" green
o 4% 1 y% 7 (INCHES) 2 3
| 4a, 3/8) 8/8, 7/8 | ' \ | | |
O
5
1
(CM)
2
3
4
5
8
7
8
<\
rey
Vis)
ee
NF RN
FEMALE
+ So 7 \
Sv 7 Se
S
SS
~
BEND
Detail 3-6B
Refer to Detail 3-6A Part A and install a male connec- -
tor pin on each of the following wires:
(_ ) 1-3/4" red (S-1).
(_) 7" black (S-1).
( ) 2-1/4” green (S-1).
Refer to Detail 3-6A Part B and position the connector
tt. *al. wartth +h
shell with ears with the point as shown. Push the male
connector pins into the holes as follows. Note: The
wat oonnerctar nine will “euck” ae thas Incki loans
ONnHECOr Pils Wil C1icK aS Wey 10CK into piace.
if a 197A" vod wriro intn hale 1
U J 2° fT LOU WLIW LEALY LEWD Ls
{ \ 7" black wire into hole 2
{ 3 Black wire into hole 2
} 2-1/4" green wire into hole 3
( ) P41: Refer to Detail 3-6B and bend the ears of the
connector shell back against the side of the
body as shown. Position the pointed end as
shown. Push the connector shell into the
mounting plate hole at P1. The ears of the con-
nector shell will lock into place at the edges of
the hole. .