Heatilator NBV3630I Installation Instructions

1
Heatilator • SIM-3630, SIM-3933, SIM-4236, SIM-4842 Decorative Front Instructions • 2382-930 Rev. B • 9/17
SIM-3630, SIM-3933, SIM-4236, SIM-4842
Installation Instructions
Leave this manual with party responsible for use
and operation.
WARNING! Risk of Fire! Combustible materials MUST
NOT overlap or be placed under a surround.
CAUTION! Risk of Cuts, Abrasions or Flying Debris.
Wear protective gloves and safety glasses during instal-
lation. Sheet metal edges are sharp.
DANGER
HOT GLASS WILL
CAUSE BURNS.
DO NOT TOUCH GLASS
UNTIL COOLED.
NEVER ALLOW CHILDREN
TO TOUCH GLASS.
A barrier designed to reduce the risk of
burns from the hot viewing glass is provided
with this appliance and shall be installed for
the protection of children and other at-risk
individuals.
CAUTION! Do not install damaged components.
WARNING! Risk of Fire! DO NOT apply combustible ma-
terials beyond the minimum clearances. Comply with all
minimum clearances to combustibles as specied. Over-
lapping materials could ignite and will interfere with proper
operation of doors and louvers.
CONTENTS:
• Decorative Front Assembly
• Shoulder Screws (2)
• Installation Instructions
PREPARATION:
• Verify and remove contents from packaging before be-
ginning installation.
• Refer to cleaning instructions on page 3.
For Models:
NDV3630I-B, NDV3630IL-B, NDV3933I-B,
NDV3933IL-B, NDV4236I-B, NDV4236IL-B,
NDV4236I-NVR, NDV4842I-B, NDV4842IL-B
NBV3630I-B, NBV3933I-B, NBV4236I-B, NBV4842I-B
NNXT3933IF-B, NNXT3933ILF-B, NNXT4236IF-B,
NNXT4236ILF-B
TOOLS REQUIRED:
• 1/4 inch drill driver with 1/4 hex bit
Proceed to “Install Hood.”
For the models listed below, it will be necessary to
remove the lower magnet latches and replace with a
shoulder screw:
NDV3630I,NDV3630IL,NDV3933I,NDV3933IL,
NDV4236I, NDV4236IL, NDV4842I, NDV4842IL
NBV3630I, NBV3933I, NBV4236I, NBV4842I
NNXT3933IF, NNXT3933ILF, NNXT4236IF,
NNXT4236ILF
TOOLS REQUIRED:
• 1/4 inch drill driver with #2 Phillips bit and 1/4 hex bit
1. Locate the magnetic latches in the bottom corners of
the appliance. Using a #2 Phillips bit, remove the two
screws retaining both latches. See Figure 1.
Figure 1. Remove Screws from Magnetic Latches
CONTENTS:
• Decorative Front Assembly
• Hood
PREPARATION:
• Verify and remove contents from packaging before be-
ginning installation.
• Refer to cleaning instructions on page 3.

Heatilator NBV3630I Specifications

General

Model	NBV3630I
Type	Gas Fireplace
Fuel Type	Natural Gas or Propane
Ignition Type	Electronic Ignition
Vent Type	Direct Vent
Log Set Material	Ceramic Fiber
Control Type	Remote Control