To Next PageTo Next Page
Need help?Do you have a question about the Heatilator ND3630I and is the answer not in the manual?
General| Brand | Heatilator |
|---|---|
| Model | ND3630I |
| Category | Indoor Fireplace |
| Language | English |
Details the appliance's certification and standards compliance.
Provides BTU input ratings and orifice sizes for different models.
Instructions for installing the appliance at elevations above 2000 ft.
Details specific installation requirements for Massachusetts.
Key factors to consider before starting installation.
Lists necessary tools and building supplies for installation.
Procedure for checking the appliance and its parts for damage.
Guidance on choosing the optimal location for the appliance.
Instructions for building the structure to enclose the appliance and vent.
Specifies minimum distances to combustible materials.
Defines maximum combustible projections above the appliance.
Specifies required clearances around the vent termination cap.
Diagram and table detailing various clearance requirements for vent terminations.
Key information for understanding vent diagrams and measurements.
Illustrations and rules for various vent configurations and elbow usage.
Clearances for pipes and framing for wall penetrations.
Installation of ceiling firestops and attic insulation shields.
Steps for preparing the appliance for top vent connection.
Steps for preparing the appliance for rear vent connection.
Instructions for properly positioning, leveling, and securing the appliance.
Detailed instructions for connecting and assembling vent pipe sections.
Installation of termination caps, shields, and storm collars.
Information on fuel type, gas pressure, and safe connection procedures.
Adjustments needed for installations at higher elevations.
Guidance on wiring and important safety warnings for electrical connections.
Instructions for wiring Intellifire and Standing Pilot ignition systems.
Steps for installing junction boxes and optional wall switches.
Defines minimum vertical and maximum horizontal mantel dimensions.
Guidance on installing facing materials around the appliance.
Steps for removing shipping materials, cleaning, and installing refractory.
Installation of firescreen, glass, grilles, hood, and accessories.
Guidance on adjusting the air shutter for optimal flame appearance.
Checks and preparations required before lighting the appliance.
Step-by-step guide for lighting the gas appliance.
Procedure for initial break-in and answers to common operational questions.
Troubleshooting guide for issues with the standing pilot ignition system.
Troubleshooting guide for issues with the Intellifire ignition system.
Diagram showing actual appliance dimensions for reference.
Illustrations and descriptions of various vent system components.
List of available service parts with part numbers and model applicability.
