Heatilator NDV42-IFT User Manual

1
Heatilator • NDV30-IFT, NDV33-IFT, NDV36-IFT, NDV36-IFT-NVR, NDV42-IFT Installation Manual • 2620-980 Rev. C • 8/20
Installation Manual
Installation and Appliance Setup
Models:
NOTICE: DO NOT discard this manual!
This appliance may be installed as an OEM
installation in manufactured home (USA
only) or mobile home and must be installed
in accordance with the manufacturer’s
instructions and the Manufactured Home
Construction and Safety Standard, Title 24
CFR, Part 3280 in the United States, or the
Standard for Installation in Mobile Homes,
CAN/CSA Z240 MH Series, in Canada.
This appliance is only for use with the type(s)
of gas indicated on the rating plate. This
appliance is not convertible for use with other
gases, unless a certied kit is used.
• DO NOT store or use gasoline or other am-
mable vapors and liquids in the vicinity of this
or any other appliance.
• What to do if you smell gas
- DO NOT try to light any appliance.
- DO NOT touch any electrical switch. DO
NOT use any phone in your building.
- Leave the building immediately.
- Immediately call your gas supplier from
a neighbor’s phone. Follow the gas sup-
plier’s instructions.
- If you cannot reach your gas supplier, call
the re department.
• Installation and service must be performed
by a qualied installer, service agency, or the
gas supplier.
WARNING:
FIRE OR EXPLOSION HAZARD
Failure to follow safety warnings exactly
could result in serious injury, death, or
property damage.
NDV30-IFT
NDV30L-IFT
NDV33-IFT
NDV33L-IFT
NDV36-IFT-NVR
NDV36-IFT
NDV36L-IFT
NDV42-IFT
NDV42L-IFT
Decorative barrier front must be ordered separately at
time of appliance purchase. See Section 3.A.
CAUTION! Risk of Fire! DO NOT store instruction manuals inside replace cavity.
High temperatures could cause a re.
INSTALLER: Leave this manual with the appliance, not inside the appliance.
CONSUMER: Retain this manual for future reference. Do not store inside the appliance.
Contact your dealer with questions regarding installation, operation or service.
DANGER
HOT GLASS WILL
CAUSE BURNS.
DO NOT TOUCH GLASS
UNTIL COOLED.
NEVER ALLOW CHILDREN
TO TOUCH GLASS.
A barrier designed to reduce the risk of
burns from the hot viewing glass is provided
with this appliance and must be installed for
the protection of children and other at-risk
individuals.

Heatilator NDV42-IFT Specifications

General

Fuel Type	Natural Gas or Propane
Venting	Direct Vent
Ignition System	Electronic Ignition
Finish	Black
Control Type	Remote Control
Log Set	Ceramic Fiber Logs
Type	Direct Vent Gas Fireplace

Summary

Product Specific and Important Safety Information

Getting Started

Inspect Appliance and Components

Instructions for checking the appliance and its parts for damage.

Framing and Clearances

Appliance Location and Clearances to Combustibles

Specifies safe distances from the appliance to combustible materials.

Constructing the Appliance Chase

Details the construction requirements for the appliance chase.

Termination Location and Vent Information

Approved Pipe

Specifies approved vent pipe types and installation warnings.

Vent Termination Minimum Clearances

Details required clearances for vent termination points.

Vent Terminal Clearances

Provides a table of minimum clearances for vent terminals.

Vent Diagrams

Illustrates various vent configurations and measurement standards.

Vent Clearances and Framing

Pipe Clearances to Combustibles

Specifies air space clearances for vent pipes to combustibles.

Wall Penetration Framing/Firestops

Details framing and firestop requirements for wall penetrations.

Ceiling Firestop/Floor Penetration Framing

Outlines framing for ceiling firestops and floor penetrations.

Appliance Preparation

Vent Collar Preparation

Steps for preparing the vent collar for top or rear venting.

Securing and Leveling the Appliance

Guides on properly positioning, securing, and leveling the appliance.

Venting and Chimneys

Assemble Vent Sections (DVP Pipe Only)

Secure the Vent Sections

Vertical Termination Requirements

Specifies requirements for vertical vent terminations and flashing.

Horizontal Termination Requirements

Details heat shield requirements for horizontal terminations.

Electrical Information

General Information

Wiring Requirements

Details wiring for the IntelliFire Touch Ignition System.

Gas Information

Fuel Conversion

Gas Pressure

Specifies required gas pressures and safety warnings.

Gas Connection

Instructions for connecting the gas supply line to the appliance.

Air Shutter Setting

Finishing

Combustible Mantel and Wall Projections

Specifies clearances for combustible mantels and wall projections.

Non-combustible Mantel and Wall Projections

Appliance Setup

Install Burner Mineral Wool

Install Fixed Glass Assembly

Install Decorative Barrier Front

Install the Log Assembly