To Next PageTo Next Page
Need help?Do you have a question about the Heatilator NDV30-IFT and is the answer not in the manual?
General| Fuel Type | Natural Gas or Propane |
|---|---|
| BTU Output | 30, 000 BTU |
| Venting | Direct Vent |
| Ignition Type | Electronic Ignition |
| Log Set Material | Ceramic Fiber |
| Burner Material | Stainless Steel |
| Type | Gas Fireplace Insert |
Details the appliance's certification by UL and standards compliance.
Outlines safety certifications and requirements for tempered glass used in appliances.
Provides a table of maximum and minimum BTU input for various models.
Instructions for adjusting appliance performance at elevations above 2000 feet.
Defines materials that do not ignite or burn, used for safety clearances.
Defines materials that can ignite and burn, relevant for clearance requirements.
Specifies adherence to National Electric Code or Canadian Electric Code for wiring.
Warning regarding chemicals like benzene, known to cause cancer in California.
Specific installation requirements for gas fueled equipment in Massachusetts.
Key factors to consider before beginning appliance installation.
Provides surface temperature guidelines for wall installations above the appliance.
Lists essential tools and building supplies required for installation.
Instructions for carefully checking the appliance and its parts for damage.
Displays actual appliance dimensions for reference in framing.
Details required clearances to walls and combustible materials.
Guidelines for building a chase to enclose the appliance and vent system.
Specifies approved venting pipes and warns against mixing manufacturers.
Safety warnings and required clearances for vent termination to prevent fire.
Detailed chart of required clearances for vent terminations in various U.S.A. and Canadian scenarios.
Explains the use of elbows and their impact on vent length calculations.
General rules and measuring standards for vent configurations.
Critical clearances and warnings for vent pipes to prevent overheating and fire.
Instructions for framing and installing firestops when penetrating walls.
Guidelines for framing openings and installing ceiling firestops for vent penetration.
Requirements for attic insulation shields to prevent contact with the vent.
Steps for preparing the appliance's vent collar for top or rear venting.
Instructions for preparing the appliance for heat management system installations.
Procedures for properly positioning, securing, and leveling the appliance.
Detailed steps for assembling DVP series vent sections correctly.
Instructions for assembling slip sections, including overlap and securing.
Guidelines for supporting vent sections to prevent sagging and separation.
Steps for safely disassembling vent pipe sections.
Procedures for installing and sealing metal roof flashing for vertical terminations.
Heat shield requirements and installation for horizontal vent terminations.
Information on installing HHT shrouds and field-constructed shroud designs.
Safety warnings and basic electrical code requirements for appliance wiring.
Detailed wiring diagrams and instructions for the IntelliFire Touch Ignition System.
Requirements and procedures for converting the appliance between gas types.
Specifies minimum/maximum inlet and manifold pressures for natural gas and propane.
Instructions for safely connecting the gas supply line to the appliance.
Guidelines for adjusting input rates for installations above 2000 feet elevation.
Procedures for adjusting the air shutter for optimal flame and venting performance.
Guidelines for applying facing and finishing materials around the appliance.
Minimum vertical and horizontal dimensions for combustible mantel and wall projections.
Guidelines for clearances and dimensions for non-combustible mantel and wall projections.
Instructions for removing protective shipping materials before operation.
Steps for cleaning sawdust and debris from inside the appliance.
Information on installing an optional refractory kit for the appliance.
Procedures for correctly placing mineral wool for burner appearance and function.
Steps for carefully installing the fixed glass assembly, ensuring proper sealing.
Instructions for installing approved decorative barrier fronts for safety.
Detailed instructions for placing the logs on the hearth pan for proper appearance.
Diagrams illustrating various DVP and SLP vent system components and their dimensions.
Diagrams and specifications for optional decorative shrouds and other components.
Information on installing and using optional accessories like remote controls and fans.
