To Next PageTo Next Page
Need help?Do you have a question about the Heatilator ND3933 and is the answer not in the manual?
General| Brand | Heatilator |
|---|---|
| Model | ND3933 |
| Category | Indoor Fireplace |
| Language | English |
Details the appliance's certification and standards compliance.
Information regarding the specifications and safety standards for the appliance's glass.
Provides details on the appliance's British Thermal Unit (BTU) output.
Guidelines for installing the appliance at higher elevations.
Defines materials that do not ignite or burn, crucial for safety clearances.
Defines materials that can ignite and burn, relevant to clearance requirements.
Specific installation requirements for the Commonwealth of Massachusetts.
Key factors to consider before designing and installing the appliance.
Lists the necessary tools and building supplies for installation.
Instructions for checking the appliance and its parts for damage before installation.
Guidance on choosing the optimal location for the appliance.
Instructions for building the vertical structure to enclose the appliance and vent.
Minimum distances required between the appliance/vent and combustible materials.
Specifies allowable dimensions for mantels above the appliance.
Defines required minimum clearances for vent termination points.
Explains symbols used in vent diagrams for vertical and horizontal lengths.
Guidelines for using 45° and 90° elbows in vent configurations.
Details standards used for vent pipe measurements.
Illustrates various vent configurations and their requirements.
Specifies required air space clearances for vent pipes to combustible materials.
Instructions for framing wall penetrations with firestops.
Steps for installing the firestop component when penetrating ceilings.
Guidance on installing shields to protect insulation from vent pipes.
Steps for preparing the appliance for a top vent configuration.
Steps for preparing the appliance for a rear vent configuration.
Procedures for properly positioning, leveling, and securing the appliance.
Instructions for connecting vent pipe sections securely.
Steps for safely taking apart vent pipe sections.
How to install heat shields and horizontal vent termination caps.
Procedure for installing roof flashing and vertical vent termination caps.
Guidance on assembling and installing the storm collar for roof vents.
Information on converting the appliance between natural gas and propane.
Details on required gas pressures for optimal performance and safety.
Instructions for safely connecting the gas supply line to the appliance.
Guidelines for installing the appliance at higher elevations.
Advice on selecting appropriate wiring for the appliance and accessories.
Safety precautions and procedures for electrical connections.
Specific wiring instructions for the Intellifire ignition system.
Wiring instructions for the standing pilot ignition system.
Steps for installing the electrical junction box.
Guide for installing an optional wall switch for the fan.
Details minimum vertical and maximum horizontal dimensions for mantels.
Guidelines for installing facing materials around the appliance.
Instructions for removing shipping materials from the appliance.
Steps for cleaning the appliance interior and control cavity.
Guidance on installing approved optional accessories.
Instructions for installing the refractory liner.
How to place decorative and ember materials for visual effect.
Procedures for removing and replacing the firescreen.
Safe handling and installation of the glass assembly.
How to install decorative grilles and trim surrounds.
Steps for attaching the appliance hood.
Adjusting the air shutter for optimal flame appearance.
Pre-operation checks and safety information before lighting.
Step-by-step guide for lighting the appliance.
Initial break-in procedure and recommendations after lighting.
Common issues and their solutions for appliance operation.
Diagnosing and resolving issues with the standing pilot ignition system.
Diagnosing and resolving issues with the Intellifire ignition system.
Diagram showing the physical dimensions of the appliance.
Visual representations of various vent system components and their specifications.
