To Next PageTo Next Page
Need help?Do you have a question about the Heatilator NOVUS series and is the answer not in the manual?
General| Fuel Type | Natural Gas or Propane |
|---|---|
| Vent Type | Direct Vent |
| Remote Control | Optional |
| Heat Output | Varies by model |
| Warranty | Limited Lifetime Warranty |
| Efficiency | Up to 70% |
Details certification standards and listing for US and Canada.
Emphasizes compliance with local building codes and national standards.
Provides specific dimensional requirements for appliance placement and clearances.
Specifies mantel height requirements based on projection for decorative models.
Details mantel height requirements for heater series models, including hood options.
Discusses horizontal vent configurations, including maximum runs and rise requirements.
Details requirements for using a 45° elbow in horizontal venting configurations.
Illustrates venting configurations using two elbows and minimum vertical sections.
Shows configurations with three elbows and minimum vertical run requirements.
Instructions for installing the rear vent heat shield for horizontal terminations.
Covers vent termination requirements, cap installation, and local code considerations.
Explains various clearance dimensions (A-O) for vent termination locations.
Details vertical termination clearances and vent length configurations.
Instructions for assembling vent pipe sections and firestop spacers.
Specifies minimum vent heights for various roof pitches for termination.
Guides on connecting the first vent section to the appliance collars.
Instructions for joining vent sections together, ensuring proper overlap and locking.
How to cut and assemble non-unitized MI vent sections.
Details how to assemble slip sections, ensuring overlap and securing with screws.
Instructions for safely separating assembled vent sections.
Addresses input rating adjustments for installations at higher elevations in the US and Canada.
Provides instructions for connecting the gas supply line to the appliance.
Specifies optimal gas supply and manifold pressures for Natural Gas and Propane.
Covers electrical wiring requirements, grounding, and connections for the appliance.
Details wiring requirements for electronic ignition systems, including thermostat connections.
Recommendations for wiring junction boxes to power optional components like fans and remotes.
Defines combustible materials used for finishing around the appliance.
Defines noncombustible materials suitable for finishing around the appliance.
Lists approved sealants and their application to prevent air leaks.
Instructions for properly attaching the appliance hood.
Steps for removing the upper grille panel for access or cleaning.
Instructions for preparing the appliance, including log set and rock wool placement.
Guidance on correctly placing the control access panel after service.
Safety precautions and operating steps for electronic ignition systems.
Procedures for safely shutting off gas to the appliance.
Safety warnings and step-by-step guide for lighting standing pilot systems.
Steps to safely turn off the gas supply to the appliance.
Instructions for starting up and shutting down standing pilot operation.
Instructions for starting up and shutting down electronic ignition operation.
Lists common issues like condensation, blue flames, and odors with possible causes.
Guidance on cleaning the burner and control compartment for optimal performance.
Recommends periodic checks of the vent system for proper operation.
How to inspect flame patterns and identify potential venting issues.
Emphasizes inspecting the appliance and venting system for obstructions.
Steps for safely cleaning the appliance glass and safety notes.
Instructions for safely removing and replacing the appliance logs.
Details the warranty coverage for various components for one year after installation.
Outlines conditions, exclusions, and limitations for warranty claims.
