39 / 48
GB
• No qualification is required except for detailed lesson of the use of unit.
• Only the persons aged 16 may work on the unit Exceptions are the youth that attend
professional education with an aim to receive the skills under the trainer supervision.
ELECTRIC SAFETY:
WARNING! It is necessary to keep basic safety device by using of this machine,
including the following instructions, to reduce the danger of fire, electric shock
and personal injury.
• Connect the machine only to such supply circuit, which is protected by current protector
with operating current max. 30mA.
• If the power cord is damaged during operation the machine, immediately disconnect from
the supply. Do not touch the cord and never work with damaged cord.
• Use only extension cords approved for outdoor use with adequate protection against
splashing water. Cross strands extension cord should be for cords up to 25 m at least
1.5mm² and for cords exceeding 25m min. 2.5mm².
• Do not use the cord to pull the plug from the socket.
• Keep the cord away from heat, oils and sharp edges.
WARNING! Do not touch the damaged cable and pull the mains plug when the
cable is damaged while working. Damaged cables increase the risk of an electric
shock. If the power supply is damaged, it must be immediately replaced with
a cable without defect, to avoid dangerous situations.
PERSON PROTECTION
WARNING! Be prepared! Have about one following things at least:
• Suitable fire extinguisher (dry powder).
• Fully equipped first-aid kit, available easily for machine operator and accompanying person.
It should contain enough pieces of bandage for lacerated/cutting wounds.
• Clean towels and clothes for angiotrispsia.
• Mobile phone or another device for quick calling of rescue service.
WARNING! Don´t work alone. There must be around another person who knows
principles of the first aid.
RESIDUAL RISKS
Even if the device is used according to instructions, it´s impossible to eliminate all the
risks associated with its operation. The following risks may occur arising from device
construction:
• Mechanical hazard, caused by cut and throw off.
• Electrical hazard caused by touch with parts under high voltage (direct contact) or with
parts, which came under a high voltage due to failure of the device (indirect contact).
• Heat hazard resulting in burning or scalding and other injuries caused by possible contact
with high temperature objects or materials including heat sources.
• Noise risk resulting in loss of hearing (deafness) and other physiological disorders (e.g. loss
of balance, loss of consciousness)
To Next Page
Loading...
