43 / 48
GB
STORAGE
• Before store the machine, unplug the power cord from the wall.
• Keep the machine in a dry place, away from children.
• Ensure that machine and connected accessories are without any pressure.
WARNING! Frost and temperatures below 0 °C, damage the machine and its
accessories, if the water is still inside the unit. Ensure the full drain and dry of the
machine.
• Pull out the power cord.
• Open the pressure pipe (release the water tap or nozzle ) and let the water drain out
completely.
• The pump must be completely empty.
• Remove the suction and pressure pipe from the machine.
• Store unit in a room sheltered against frost (+5 °C at least).
WARNING! The machine cant be stored in an unprotected place, outdoors or in wet!
TROUBLESHOOTING
NOTE: Technical problems on your machine which require more qualified
intervention must always solve an authorized service. Improper interference can
cause damages. If you fail to rectify the problems with instructions described
below, contact an authorized service center.
Low voltage
Use extension cable with sufficient diameter
with respect to its length
Ensure the correct voltage
The pump is clogged or had broken down
Clean the pump or contact authorized service
center
The pump doesnt suck properly or is too
noisy
Ensure, that the pump has the water enough
The suction pipe leaks
Seal the pipe, tighten the screws
Dont exceed the maximum prescriped
suction height
Suction filter (accessory) is blocked Clean or change
Check valve (accessory) is blocked Clean or change
Water flows between engine and pump, the
shaft seal is wrong
Shaft seal has to be changed by authorized
service
The pressure is too low
The suction pipe leaks or the suction height
is too big
To Next Page
Loading...
