12 / 20
PL
SK
DE
EN
CS
HU
SAFETY INSTRUCTIONS
WARNING! B
Failure to follow the warnings and instructions may result in electric shock, fire and/
or serious injury.
The use of other accessories or attachments other than those specified in
the instructions for use, can cause injury.
• Get to know this product. Carefully read the instruction manual. Learn how to use this
product, all restrictions, and what risks could related with its use. Learn the product quickly
stop and turn off the controls.
• Be careful at work, be concentrated on actual work, and use the common sense.
• If the product is not in use, it should be stored in a dry and secure place out of the reach of
children.
• Never pull the plug from the socket by pulling on the cord. Keep the supply cord away from
heat, grease and sharp edges.
• Always disconnect the product from the mains supply before repairing, when changing
accessories, and when the product is not used.
• If the product is used outside, use only extension cord designed for outdoor use and marked
as such.
• Pay attention to what you are doing, be concentrated and think sensibly, do not work with
the product if you are tired, under the influence of alcohol, drugs or medication.
• Faulty switches must be entrusted to an authorised repair service for replacement.
• Do not use this product if the main switch does not allow it to switch on or off.
• This product is designed in accordance with all applicable safety requirements and standards
applicable to it. All repairs should be only made by qualified person and spare parts replaced
by original parts, otherwise the user may be in serious danger.
ELECTRICAL REQUIREMENTS
• Never use at the nominal voltage other than 230V/50Hz. The circuit must be properly and
accordingly current protected.
RECOMMENDATIONS FOR PROTECTION CLASS II MACHINES
• Machines must be powered via a current protector (RCD) with a maximum 30 mA tripping
current.
EXTENSION LEAD
• Always use a double-insulated power supply and the parameters corresponding to
the machine’s power consumption. The minimum cross section of the cable must be determined
according to the current or power data on the fork/label of the machine. It‘s not only necessary
to take the load into account, but also the length of the extension lead and the type of fuse.
• Position power supply cable so it does not interfere with the work and is not damaged.
• Only use rubberised extension cables with sufficient conductor cross section and fully
developed.
To Next Page
Loading...
