hecht 3809 - Unpacking; Assembly

13 / 20
PL
SK
DE
EN
CS
HU
Minimum cross-sections of the e fully developed extension cord:
up to 6 A including: > 0.75 mm
2
up to 10 A including: > 1.0 mm
2
up to16 A including: > 1.5 mm
2
Maximum cable length in relation to the cross section
Cable cross section (mm
2
) 0,75 1 1,5 2,5
Maximum possible length (m) 30 40 60 100
Note: I
The correct maximum load of the extension cable must always be indicated on its
label.
UNPACKING
• Carefully check all parts after unpacking the product from the box.
• Do not throw away packaging materials until you have not reviewed carefully if they did not
remain a part of the product.
• Parts of the packaging (plastic bags, paper clips, etc.) do not leave within reach of children,
could be a possible source of danger. There is a danger of swallowing or suffocating!
• If you notice transport damage or while unpacking, notify your supplier immediately. Do not
operate the product!
• We recommend save the package for future use. The packaging materials must still be
recycled or disposed of in compliance with the relevant legislation. Sort different parts of
the packaging according to material and hand it to the appropriate collection sites. For
further information contact your local administration.
C Fasteners can become loose during transport in the packaging.
PACKAGE CONTENTS
1x fan body, connecting material, remote control, instructions for use
• Standard accessories are subject to change without notice.
• This product requires assembly. The product must be assembled correctly before use.
ASSEMBLY
ASSEMBLE THE WHEELS:
• Place the appliance on a flat surface. Remove the key from the foam case and install
the wheels.
• Beware of possible confusion: the rear wheels have a brake, the front do not.
FILLING:
• Slide the water tank out of the appliance and pour water into it. The water level in the tank
must not exceed the ‘MAX’ mark on the scale. The water level should never fall below the
‘MIN’ mark when in operation.
• If you want to increase the efficiency of cooling, add ice or frozen freezer pack into the water
tank. However, the total tank level must not exceed the ‘MAX’ mark.