31 / 48
PL
SK
DE
EN
CS
HU
or unusually large humidity or dust, contact your service on the recommendations
applicable to your individual needs and the way of using the machine in your case.
MACHINE MAINTENANCE
• Keep the machine in good condition.
• Careful handling and regular cleaning ensure that the machine remains functional and
efficient for a long time.
• In case of abnormal vibrations proceed according to instructions (see instruction for removal
of fault).
• Keep all nuts, bolts and screws tight to be sure the equipment is in safe working condition.
• Always ensure that the ventilation openings are kept clear of debris.
• Replace worn or damaged parts for safety. Use only original spare parts.
• Replace safety and instruction stickers and labels with new if necessary.
• Frequently check the collection basket for wear or damage.
• Always be careful when adjusting the machine to avoid jamming fingers between moving
blades and rigid machine parts.
• Regularly check the blade for damage.
CLEANING
CAUTION! A
Do not hose engine. Water can damage engine or contaminate the fuel system.
• If the engine has been running, allow it to cool for at least half an hour before cleaning.
• After use, clean the outside of the machine, empty the grass-catcher and shake it to remove
grass and other debris.
• Clean the mower thoroughly from grass and dirt after each mowing. Clean particularly
the area under the chassis around the blade, the ejection tunnel to the grass bag, and
the space around the gearbox on the rear wheel axle (only for self-propelled mowers). Make
sure that the blade or its carrier is not damaged. Also, visually check that the V-belt cover in
the area above the blade is not loosened or otherwise damaged.
• Clean under deck by tilting the machine so that the spark plug is always up.
• Wipe the surface of the machine and engine cover with dry cloth. Clean the cover of
the machine, especially the ventilation holes.
• Do not let the handles contaminate with oil or grease. Clean the handle clean with a damp
cloth washed in soapy water.
• Do not use solvents or petrol! This can cause irreparable damage to the product. The plastic
parts can be eaten away by chemicals.
• Clean wheels, coat of grass can change the height of cut.
• If any of the parts of the machine is cleaned by water or a damp cloth, etc., it must be
completely dry. Then the metal parts must be grease against the corrosion with suitable
protective oil. Make sure that the water doesn´t leak into the internal parts of the machine.
• If there is a connection to a garden hose on part of the machine, it is possible this part wash
by water. Then it is necessary the whole washed part of the machine and places where
the water were sprayed when cleaning, completely dry and grease agains the corrosion with
suitable protective oil.
• We do not recommend washing the machines with pressure washer.
To Next Page
Loading...
