Hefter Systemform TF MEGA-M - Page 53

3-23
&KDSWHU$'9$1&('23(5$7,21
Note that you cannot move onto the
next procedure until you place paper
on the paper feed table.
23
Store the cross folding lever.
4-2. Cross Folding Non-Standard Size Paper
3DSHURWKHUWKDQWKHVL[VWDQGDUGVL]HSDSHUDUHFDOOHGQRQVWDQGDUGVL]HSDSHU7KHSDSHUVL]HWKDW
can be cross folded is as follows.
Length:182 to 432 mm
Width:128 to 297 mm
Paper feeding direction
0D[LPXP:[/PP
0LQLPXP:[/PP
The following describes the cross single folding
SURFHGXUHVRIPPORQJSDSHUDVDQH[DPSOH
1
Fold the paper into two according to
Chapter 3 "ADVANCED OPERATION"
"3.Standard Folding of Non-Standard
Size Paper" (
p.3-15).
L
Paper feeding direction
2
Measure the length (L) of the single-
folded paper.
3
Press along the folded line of the
VLQJOHIROGHGSDSHU¿UPO\ZLWK
\RXU¿QJHUVWRSUHYHQWWKHSDSHU
from slipping and buckling in the
horizontal direction when folded.