Hegner Mk 4 User Manual

I{EENER
rnstall-ation rnstructions
for MK
4
slidins
rabl-e
Attach the complete sliding
table
assembly
to the
MK 4
saw table
using
the machine screws No.
2
with washers.
The
sliding table surface
should be approximately
.020"
(0,5
mm) above the
fixed table surface.
This
is adjusted
as
fo}lows.
Slightly
loosen
the
two No.
2 machine screws.
Adjust
set
screws
No. 4 until
the correct
height is
achieved. Be
sure
table
is
leve1..
Finally,
retighten No. 2
screws.
Tischplatte
fixed tabl
bz
AMI,LTD.,2
MGCUTLOUGH
DRIVE,
SOUTHCATE
INDUSTRIAL
PARK,
NEW
CASTLE,
DE19720,
PHONE
(3021
322-2226

Hegner Mk 4 Specifications

General

Brand	Hegner
Model	Mk 4
Category	Saw
Language	English

Summary

MK 4 Sliding Table Installation

Attaching the Sliding Table Assembly

Instructions for attaching the complete sliding table assembly to the MK 4 saw table using machine screws and washers.

Adjusting Table Surface Height

Procedure to adjust the sliding table surface height to approximately .020" above the fixed table using set screws.

MK 4 Sliding Table Parts Identification

Parts Numbers Diagram

Exploded view diagram displaying the MK 4 Sliding Table components with associated part numbers.

MK 4 Sliding Table Component List

Parts List and Quantities

Comprehensive list of MK 4 Sliding Table parts, detailing item numbers, names, and quantities.