Hegner Multicut-2S - User Manual

Super- Universal- Fine Cut Saws
Original operating instructions
Multicut-1
Multicut-2S
Multicut-SE
Multicut-Quick
Serial no.:
Important
In order to prevent the risk of accidents, please
read the operating instructions carefully before
installation and use of the machine.
Always keep these operating instruction
near to the machine.
It is important that these instructions are
always available for reference purposes.
holzstaubgeprü
G
A
R
A
N
T
I
E
G
A
R
A
N
T
I
E
G
U
A
R
A
N
T
E
E
3
J
A
H
R
E
A
N
S
Y
E
A
R
S
*
*Except electronics (1 year)
and wearing parts

Summary

1.0 Technical Data

3.0 Operating instructions

4.0 Proper use

5.0 Safety notes

5.1 General safety notes

Covers essential safety precautions, including keeping unauthorized persons away and wearing protective goggles.

6.0 Remaining risks

8.0 Commissioning and Decommissioning

8.1 Commissioning the machine

Prerequisites and steps for safely commissioning the machine, including checks and saw blade tensioning.

8.2 Switching on the machine

Procedure for safely switching on the machine, including clearing the work area and connecting the vacuum cleaner.

8.3 Switching off the machine

Instructions for brief interruptions, covering switching off the machine and vacuum cleaner.

9.0 Changing the Saw Blade

9.4 Remove saw blade from machine

Detailed steps for removing the saw blade from the machine's holders.

9.5 Remove saw blade from saw blade clamps

Instructions on how to remove the saw blade from its specific clamps.

9.6 Clamp new saw blade in saw blade clamps

Guidance on correctly inserting and clamping a new saw blade into the clamps.

9.7 Insert saw blade with clamp in machine

Procedure for inserting the clamped saw blade back into the machine's swing arms.

10.0 Changing the Saw Blade for Internal Cutting

10.4 Clamp the saw blade

Steps for clamping the saw blade using the special clamp, ensuring it is correctly seated.

10.5 Tensioning the saw blade

Procedure for tensioning the saw blade when using the special clamp for internal cutting.

11.0 Swivelling the Table Plate

11.2 Swivel table plate

Instructions on how to adjust the table plate for angled cuts up to 45 degrees.

12.0 Adjusting the Stroke Length

12.5 Adjust the stroke length

Guidance on selecting threaded bores to set either a short or long saw stroke.

12.6 Clamp the connecting rod

13.0 Extraction Connection

14.0 Maintenance and Cleaning

14.1 Maintenance - Oil arm bearings

14.2 Maintenance - inspection

14.3 Cleaning

14.3.2 Clean the machine

15.0 Repair and Spare Parts

15.1 Repair

Important notes on repairing the machine, emphasizing professional repair for electrical parts and user responsibility.

17.0 Speed Selection

18.0 Operating Mistakes and Causes

Hegner Multicut-2S Specifications

General

Type	Scroll Saw
Motor Power	100W
Voltage	230V
Max. Cutting Thickness	50 mm
Throat Depth	460 mm
Table Size	435 x 230 mm
Blade Length	130 mm
Blade Clamp	Quick-clamp system