Hegner Multicut-2S - 14.2 Maintenance - inspection; 14.3 Cleaning; 14.3.2 Clean the machine; 15.0 Repair and Spare Parts

14.2 Maintenance – inspection
• With the machine switched off, carry out a visual
inspection at regular intervals and check the parts
of the machine for damage, above all
- the plug
- the power cable
- the terminal box
• If damage is found in particular to the electrical
equipment, decommission the machine
immediately and arrange for professional repair
with original spare parts.
14.3 Cleaning
-
Clean the machine according to the level of dirt.
- No deposits of dust or chippings should form on or in
the machine.
14.3.1 Decommission machine
⇒ 8.4 Decommissioning the machine
14.3.2 Clean the machine
• Clean the machine by extracting the dust with a
vacuum cleaner.
• Remove the side protective cover from time to time
and remove any dust below it.
• Remove sticky deposits with a brush or similar.
• Do not use any
- flammable
- aggressive or
- scouring cleaning agents
• Prevent the penetration of fluid / liquid into the
machine and in particular the electrical parts.
• If however moisture or fluid enters the machine,
do not connect the machine to the power supply.
• In this case contact the dealer or manufacturer.
1
5.0 Repair / Spare parts
These operating instructions do not contain any repair
i
nstructions. Parts are repaired and / or replaced at
your own risk.
• The following notes must be observed.
15.1 Repair
• Do not repair any (faulty) electrical machine parts.
• These parts must be replaced by original spare
parts from the manufacturer.
• Only the manufacturer or authorised dealer /
specialist with corresponding training (e.g.
electricians) may replace electrical machine parts.
•
If incorrect D.I.Y. work is performed on electrical
machine parts, there is a risk of life-threatening
current surges and/or burns.
• The person responsible is liable for all damage or
injury caused in this way.
Faulty or worn machine parts:
- may in principle only be replaced by the manufacturer
/ authorised dealer or specialist with corresponding
training.
- may be replaced by the user with original parts from
the manufacturer if the user has the necessary
mechanical knowledge.
- The person responsible is liable for injury and/or
damage caused by incorrect repair or replacement
work by the user or other unauthorised persons.
If you still wish to repair your machine yourself:
• first disconnect the power switch and remove the plug
from the socket.

☞



☞
11