Hegner Multicut-2S - 8.2 Switching on the machine; 8.3 Switching off the machine

8.2 Switching on the machine
⇒ Fig. 8-3
Warning:
The machine starts to work as soon as it is switched
o
n.
•
First remove all tools, workpieces, residue and
chippings from the working area.
• Connect the plug to the socket and switch the
machine on with the power switch (1) by pressing the
r
ocker switch down (I).
•
Switch on the vacuum cleaner.
8.3 Switching off the machine
(for brief interruptions)
⇒ Fig. 8-4
• Switch off the machine with the power switch (1) by
pressing the rocker switch up (O).
• Switch off the vacuum cleaner.
• Remove all tools, workpieces, residue and chippings
from the working area.
8.4 Decommissioning the machine
(for longer stoppages, change-over, end of work etc.)
• Switch off the machine with the power switch (1) by
pressing the rocker switch up (O) and remove the
plug from the socket.
• Release the fretsaw blade.
• Remove all workpieces, residue and chippings from the
working area.
9.0 Changing the Saw Blade
9.1 Switch off saw
⇒8.4 Decommissioning the machine.
9.2 Release saw blade
⇒8.1.2 Release saw blade.
Also release the saw blade if the blade is broken.
9.3 Fold protective cover down
⇒ Fig. 9.1
• Fold protective cover (1) down.
• Also remove chippings and residue from the protective
cover.

6
Fig. 8-3
Fig. 8-4
Fig. 9-1
1
1
1