HEIDELBERG Suprasetter A75 User Manual

Service and Maintenance
Suprasetter A52/A75 – User’s Guide 89
Replacing the Filter Kit in the Suction
Device (Option)
A message prompts the user to change the air filter in the suction device.
Maintenance interval: 25,000 m
2
plate material
Order number of the filter kit: PJ.570.280
The filter kit consists of a high efficiency submicron particulate air filter, a pre-
liminary filter, disposable gloves and a light dust mask.
Note: Manufacturers of the plates we recommend point out that users
are exposed to no harm from any pollutants released through the use of
their plates. Please take note of the information supplied by the plate
manufacturers. You are advised to request this information if you do not
have it.
Note: After you remove the filters, clean the casing with a vacuum
cleaner. Place the used filters, disposable gloves, dust mask and vac-
uum cleaner bag in a plastic bag, tie the bag up and dispose of it as gen-
eral commercial waste. If you are not sure about disposal procedures,
contact your local waste disposal company for details.
We strongly recommend that you also proceed as described above if you
use plates that are not recommended by Heidelberg. It is essential to
take note of the information supplied by the plate manufacturers. You
are advised to request this information if you do not have it.
CAUTION
Risk of injury from improper handling
We recommend that you wear the disposable gloves and
light dust mask included in the kit when you are changing
the filters.
i
i
i
i

HEIDELBERG Suprasetter A75 Specifications

General

Brand	HEIDELBERG
Model	Suprasetter A75
Category	Printer
Language	English