HEIDENHAIN ND 710 - User Manual

6/99
Position Display Units
for Milling Machines
User’s Manual

Summary

About this Manual

Manual Structure Overview

Outlines the two main parts of the manual: Operating Instructions and Installation/Specifications.

Part I Operating Instructions

Fundamentals of Positioning Concepts

Datum Setting Procedures

Describes how to set reference points (datums) for workpiece machining.

Positioning Displays: Nominal, Actual, and Distance-to-Go

Encoder and Reference Mark Operation

Initial Power-On and Reference Marks

Guides users through the initial power-on and reference mark setting procedure.

Tool Compensation Setup

Details how to enter tool length and diameter for compensation.

Using Distance-To-Go for Axis Movement

Explains how to use the distance-to-go feature for positioning.

Bolt Hole Circle and Segment Creation

Describes how to create bolt hole circles and segments.

Linear Hole Pattern Generation

Applying Scaling Factors

Troubleshooting: Error Messages

Lists common error messages and their causes and solutions.

Part II Installation and Specifications

Encoder Connection Procedures

Operating Parameters Overview

Multipoint Axis Error Compensation

Explains how to compensate for non-linear axis errors using multiple points.

Axis Error Compensation Steps

HEIDENHAIN ND 710 Specifications

General

Brightness	400 cd/m²
Contrast Ratio	500:1
Operating Temperature	0 °C to 45 °C
Display Type	LCD
Power Supply	24 V DC
Power Consumption	15 W