2 – 10 HEIDENHAIN Service Manual TNC 426/430 C/P/M
Dist value too small 1590 n The value entered for 'DIST' in the
digitizing cycle 16.0 MEANDER or
18.0 LINE is smaller than the
minimum permissible distance that
the TNC calculates from the
machine data.
n Press <NO ENT> to delete value
for 'DIST'. The TNC enters a value
automatically.
Current to axis
%.1s not equal 0
2657 n The axis motor is receiving current,
although its inverter was switched
off!
n Inform your service agency.
Axis %.1s: MP112 /
MP113 incorrect
2200 n MP112 / MP113 for the displayed
axis is incorrect
n Inform your service agency.
Axis %.1s: MP120 /
MP121 incorrect
2201 n MP120 / MP121 for the displayed
axis is incorrect
n Inform your service agency.
Axis %.1s: MP2190
incorrect
2199 n MP2190 for the displayed axis is
incorrect
n Inform your service agency.
Axis %.1s: MP2340
/ MP2350 incorrect
2198 n MP2340 / MP2350 for the displayed
axis is incorrect
n Inform your service agency.
Axis %.1s: MP2540
/ MP2550 incorrect
2202 n MP2540 / MP2550 for the displayed
axis is incorrect
n Inform your service agency.
Axis double
programmed
307 n In the Contour Lines cycles (TCH
PROBE 7) you programmed the
starting position in one axis twice.
n Edit the part program.
Axis double
programmed
308 n You programmed an axis twice in a
single positioning block.
n Edit the part program.
Axis double
programmed
309 n You programmed an axis twice in
the Mirror Image cycle.
n Edit the part program.
Axis double
programmed
310 n You called a Slot Milling or
Rectangular Pocket cycle in which
the same axis is programmed for
length and width.
n Edit the part program.
Axis double
programmed
311 n While defining Cycle 26 (axis-
specific scaling factor), you
programmed the scaling factor or
the scaling datum twice in one axis.
n Edit the part program.
Axis locked 2285 n The datum point for this axis is
disabled in Machine Parameter
7295.
n Edit machine parameter 7295:
Input value 0 allows the datum to
be set in all axes.
Axis not at test
position
3219 n Safety-oriented function:
The axis moved from the test
position before you pressed the
permissive button.
n Reapproach the test position.
Axis cannot be
shown
860 n Simulation of a movement in the
axes A, B, C, U, V, W is not possible
in the graphics.
n xxxx
Axis geometry not
defined
336 n You programmed Cycle 27 (Cylinder
Surface, ISO: G127), although in
machine parameters 7510 and
following no rotary axis, or the
programmed rotary axis, is not
configured.
n Define the correct rotary axis in the
contour subprogram.
n Have the machine manufacturer
check parameter 7510 and
following.
Axis configuration
not equal 0
2696 n The safe inputs for the axis
configurations are not equal to 0 V.
n Inform your service agency.
Error message Error
number
Cause of error Corrective action
To Next Page
Loading...
