2 – 18 HEIDENHAIN Service Manual TNC 426/430 C/P/M
CYCL CALL PAT
not permitted
3189 n You have used Cycle 12 (ISO: G39)
to declare a program containing
CYCL CALL PAT to be a cycle.
n CYCL CALL PAT in connection with
cycle 12 (ISO: G39) is not
permitted.
CYCL DEF not
defined
261 n You have programmed a cycle call
without having first defined a fixed
cycle.
n You attempted to call a cycle that
automatically becomes active upon
definition.
n Define the cycle call after definiton
of a fixed cycle.
n Delete the cycle call.
CYCL DEF
incomplete
260 n You deleted part of a cycle.
n You have inserted other part-
program blocks within a cycle.
n Redefine complete cycle again.
n Delete NC blocks within cycle.
CYCL parameter
incorrect
447 For digitizing cycles:
n Probe point interval greater than 65
535 (with Q parameter).
n Incorrect line-by-line digitizing axis.
n Check the entries in the digitizing
cycle.
File %.16s is
missing
498 n Error in compensation value
conversion: The *.COM file
selected in the *.CMA file does not
exist.
n Load the file.
File %.16s is
missing
499 n "PGM not found" error message
during Include in ASCII file.
n Load the file.
File %s%s already
exists
2498 n You have already used the entered
file name for another file type.
n Select a new file name or delete
the existing file.
File empty 2225 n You attempted to select a tool
material or a cutting material
although the corresponding table
has no entries.
n Enter the missing workpiece
material in the file MAT.TAB or the
missing cutting material in the file
CUT.TAB.
File not found. 2382 n In your program you called a file or a
table that does not exist in your
TNC.
n Enter the name of an existing table.
File not found in
OEM.SYS
2222 n You attempted to use a workpiece-
material table or a tool-material
table, although your machine
manufacturer has not made the
required entries in OEM.SYS.
n The OEM.SYS must be changed.
Contact your machine tool builder.
File format has
changed
1186 n This error message will be
displayed when opening a binary
file (*.H,*.T...) if the binary format
has changed since the last output
version.
n Delete the file.
File name on data
medium assigned
1035 n The file name already exists on the
external data medium.
n Select with the YES/NO key
whether to overwrite the file.
Program name
already exists
186 n You attempted to create a file that
already exists.
n Use another file name.
Program name
already exists
944 n This file name already exists. n Select another file name.
File system error 1 1160 n Incorrect cluster number in the
"get_cluster" routine, caused by a
software error.
n Inform your service agency.
File system error 2 1161 n Incorrect cluster number in the
"put_cluster" routine, caused by a
software error.
n Inform your service agency.
File system error 3 1162 n Incorrect cluster number in the
"next_cluster" routine, caused by a
software error.
n Inform your service agency.
File system error 4 1163 n Incorrect cluster number in the
"update_cluster" routine, caused by
a software error.
n Inform your service agency.
Error message Error
number
Cause of error Corrective action
To Previous Page
Loading...
