HEIDENHAIN TNC 640 - Page 102

Introduction | Status displays
2
102
HEIDENHAIN | TNC 640 | Conversational Programming User's Manual | 10/2017
Information on standard cycles (CYC tab)
Soft key Meaning
No direct
selection
possible
Active fixed cycle
Active values of Cycle 32 Tolerance
Active miscellaneous functions M (M tab)
Soft key Meaning
No direct
selection
possible
List of the active M functions with fixed
meaning
List of the active M functions that are adapted
by your machine manufacturer
Positions and coordinates (POS tab)
Soft key Meaning
Type of position display, e.g. actual position
Tilt angle of the working plane
Angle of basic transformations
Active kinematics