HEIDENHAIN TNC 640 - Page 274

Tools | Tool management (option number 93)
6
274
HEIDENHAIN | TNC 640 | Conversational Programming User's Manual | 10/2017
Editing with active form view
If the form view is active, the following functions are available to
you:
Soft key Editing functions, form view
Select the tool data of the previous tool
Select the tool data of the next tool
Select previous tool index (only active if indexing is
enabled)
Select the next tool index (only active if indexing is
enabled)
Open a pop-up window for selection (only available
for selection fields)
Discard all changes made since the form was called
Calculate the measured values of tool compensation
(only active for turning tools)
Add tool index
Delete tool index
Copy the tool data of the selected tool
Insert the copied tool data in the selected tool