Fundamentals | Control model, software and features
HEIDENHAIN | TNC 640 | Conversational Programming User's Manual | 10/2017
29
New functions 34059x-08
New function Global Program Settings (option 44), see "Global
Program Settings (option 44)", page 519
The new Batch Process Manager function enables you to
plan production orders, Further information: "Batch Process
Manager", page 665
New FUNCTION PROG PATH function for taking the entire
tool radius into account in 3-D radius compensation, see
"Interpretation of the programmed path", page 640
New FACING HEAD POS function for working with facing slides,
see "Using a facing slide", page 707
Touchscreen operation is supported, see "Operating the
Touchscreen", page 131
When an application is active on the third or fourth desktop, the
operating mode keys are also effective with touch operation,
see "Save elements and switch to the NC program", page 141
Using DRS it is now possible to define a cutter radius oversize
for a turning tool, see "Tool compensation in the program",
page 687, see "Tool data", page 688
The AFC function (option 45) can now also be used in turning
mode, see "Cutting force monitoring with the AFC function",
page 711
The M138 function is now also effective in turning mode.
The TCPM function (option 9) was expanded by the selection
of the tool reference point and the center of rotation, see
"Selection of tool reference point and center of rotation",
page 629
New tool-oriented pallet machining function, see "Tool-oriented
machining", page 660
New pallet preset management, see "Pallet preset
management", page 659
If a pallet table is selected in a Program Run operating mode,
the Tooling list and T usage order are calculated for the
entire pallet table, see "Tool management (option number 93)",
page 270
New FUNCTION COUNT function for controlling a counter, see
"Defining a counter", page 564
New FUNCTION LIFTOFF function for retracting the tool from
the contour upon an NC stop, see "Lift off tool at NC stop:
FUNCTION LIFTOFF", page 581
Dynamic Collision Monitoring (DCM) is now also available in the
Test Run operating mode, see "Collision monitoring in the Test
Run operating mode", page 509
You can also open the tool-carrier files in the file management,
see "Tool carrier management", page 514
With the ADAPT NC PGM / TABLE function, you can also import
and modify freely definable tables, see "Importing tool tables",
page 252
The machine tool builder can define update rules that make it
possible, for example, to automatically remove umlauts from
tables and NC programs when importing a table, see "Importing
tool tables", page 252
To Next Page
Loading...
