Programming Q Parameters | Additional functions
10
HEIDENHAIN | TNC 640 | Conversational Programming User's Manual | 10/2017
425
Group
name
Gruppen-
nummerID
Systemdaten-
nummer
Index Description
9 - Tool orientation (TO)
10 - Angle of spindle orientation (ORI)
11 - Tool angle P_ANGLE
12 - Point angle T_ANGLE
13 - Recessing width CUT_WIDTH
14 - Type (e.g. roughing, finishing, threading,
recessing or button tool)
15 - Length of cutting edge CUT_LENGTH
16 - Compensation of workpiece diameter
WPL-DX-DIAM in the working plane coordi-
nate system WPL-CS
17 - Compensation of workpiece diameter
WPL-DZL in the working plane coordinate
system WPL-CS
18 - Recessing width oversize
19 - Cutting radius oversize
Freely available memory area for tool management
956 0-9 - Freely available data area for tool manage-
ment. The data is not reset when the
program is aborted.
Transformation data for general tools
1 - Position within the tool system explicitly
defined:
2 - Position defined by directions:
3 - Shift in X
4 - Shift in Y
5 - Shift in Z
6 - X component of the Z direction
7 - Y component of the Z direction
8 - Z component of the Z direction
9 - X component of the X direction
10 - Y component of the X direction
11 - Z component of the X direction
12 - Type of angle definition:
13 - Angle 1
14 - Angle 2
960
15 - Angle 3
To Next Page
Loading...
