HEIDENHAIN TNC 640 - Page 471

Programming Q Parameters | Preassigned Q parameters
10
HEIDENHAIN | TNC 640 | Conversational Programming User's Manual | 10/2017
471
Tool measurement with the BLUM laser Parameter value
Reserved Q190
Reserved Q191
Reserved Q192
Reserved Q193
Reserved for internal use Parameter value
Marker for cycles Q195
Marker for cycles Q196
Marker for cycles (machining patterns) Q197
Number of the last active measuring cycle Q198
Status of tool measurement with TT Parameter value
Tool within tolerance Q199 = 0.0
Tool is worn (LTOL/RTOL is exceeded) Q199 = 1.0
Tool is broken (LBREAK/RBREAK is exceed-
ed)
Q199 = 2.0
Checking the setup situation: Q601
The value of the parameter Q601 indicates the status of the
camera-based monitoring of the VSC setup situation.
Status Parameter value
No error Q601 = 1
Error Q601 = 2
No monitoring area defined or not enough
reference images
Q601 = 3
Internal errs (no signal, camera fault, etc) Q601 = 10