HEIDENHAIN TNC 640 - Page 522

Special Functions | Global Program Settings (option 44)
12
522
HEIDENHAIN | TNC 640 | Conversational Programming User's Manual | 10/2017
Activating Global Program Settings
All changes must be confirmed with the Ok soft key.
Otherwise the control discards the changes when
closing the form, e.g. by pressing the END key.
Press the GLOBAL SETTINGS soft key
The control opens the form with the following
elements:
Check boxes, e.g. for the settings possibilities
Input fields for the entry of values
Pull-down menu of the coordinate systems
for Handwheel superimp.:
Using form elements to activate a setting
possibility
Further information: "Using the form",
page 523
Press the Ok soft key
The control applies the settings and closes the
form
Deactivating Global Program Settings
All changes must be confirmed with the Ok soft key.
Otherwise the control discards the changes when
closing the form, e.g. by pressing the END key.
After selecting the NC program, press the
CHANGE DATA soft key
Or, if the NC program is already open, press the
GLOBAL SETTINGS soft key
The control opens the form
Press the GLOBAL SETTINGS INACTIVE soft key
in order to deactivate all settings possibilities
As an alternative, use form elements to
deactivate a setting possibility
Further information: "Using the form",
page 523
Press the Ok soft key
The control applies the settings and closes the
form