Special Functions | Global Program Settings (option 44)
12
532
HEIDENHAIN | TNC 640 | Conversational Programming User's Manual | 10/2017
NOTICE
Danger of collision!
The coordinate system selected in the pull-down menu also
takes effect on Handwheel superimp.: with M118, even if the
Global Program Settings function is not active. There is risk of
collision during the execution of Handwheel superimp.: and
during the subsequent machining operations!
Before exiting the form, always make sure to explicitly select
the Machine Coordinate System (M-CS).
Test the behavior at the machine
To Next Page
Loading...
