Turning | Tools in turning mode (option 50)
16
686
HEIDENHAIN | TNC 640 | Conversational Programming User's Manual | 10/2017
16.4 Tools in turning mode (option 50)
Tool call
Just as in Milling mode, turning tools are called with the TOOL
CALL function. You merely have to enter the tool number or tool
name in the TOOL CALL block.
You can call and insert a turning tool both in Milling
mode and in Turning mode.
Tool selection in the pop-up window
If you open a pop-up window for tool selection, the control marks
all tools available in the tool magazine green.
In addition to the tool number and tool name, the control also
shows the ZL and XL columns from the turning tool table.
Example
1 FUNCTION MODE TURN
Turning mode selection
2TOOL CALL "TRN_ROUGH"
Tool call
...
To Next Page
Loading...
