HEIDENHAIN TNC 640 - Page 847

MOD Functions | Counter settings
20
HEIDENHAIN | TNC 640 | Conversational Programming User's Manual | 10/2017
847
20.3 Counter settings
With the MOD function Counter settings, you can change the
current count (actual value) and the target value (nominal value).
Proceed as follows to select the Counter settings:
In the MOD menu, select the Counter settings group
Select the current count
Select the target value for the counter
Press the APPLY soft key
Press the OK soft key
The control immediately takes over the selected value in the status
display
You can change the Counter settings via soft key as follows:
Soft key Meaning
Reset count
Increase count
Lower count
You can also enter the values directly with a connected mouse.
Further information: "Defining a counter", page 564