MOD Functions | Machine settings
20
HEIDENHAIN | TNC 640 | Conversational Programming User's Manual | 10/2017
851
Tool usage file
Refer to your machine manual.
The tool usage test function must be enabled by your
machine tool builder.
With the MOD function Tool-usage file, you can select whether
the control never, once, or always creates a tool usage file.
Generate a tool usage file:
In the MOD menu, select the Machine settings group
Select the Tool-usage file menu
Select the desired setting for the Program Run, Full Sequence/
Single Block and Test Run operating modes
Press the APPLY soft key
Press the OK soft key
To Next Page
Loading...
