HEIDENHAIN TNC 640 - Page 861

MOD Functions | Setting up data interfaces
20
HEIDENHAIN | TNC 640 | Conversational Programming User's Manual | 10/2017
861
Define behavior after receipt of ETX
(noEotAfterEtx no. 106710)
With define behavior after reception of ETX (optional) you
determine whether the EOT character is sent after the ETX
character was received.
TRUE: The EOT character is not sent
FALSE: The EOT character is sent
Settings for the transmission of data using PC
software TNCserver
Apply the following settings in machine parameter RS232
(no. 106700):
Parameters Selection
Data transfer rate in baud Has to match the setting in
TNCserver
Data transmission protocol BLOCKWISE
Data bits in each transferred
character
7 bits
Type of parity checking EVEN
Number of stop bits 1 stop bit
Specify type of handshake: RTS_CTS
File system for file operations FE1