HEIDENHAIN TNC 640 - Page 906

Tables and Overviews | Technical Information
21
906
HEIDENHAIN | TNC 640 | Conversational Programming User's Manual | 10/2017
Adaptive Feed Control – AFC (option 45)
Adaptive Feed Control Milling:
Recording the actual spindle power by means of a teach-in cut
Defining the limits of automatic feed rate control
Fully automatic feed control during program run
Turning (option 50):
Cutting force monitoring during machining
KinematicsOpt (option 48)
Optimizing the machine kinematics Backup/restore active kinematics
Test active kinematics
Optimize active kinematics
Mill-Turning (option 50)
Milling and turning modes Functions:
Switching between Milling/Turning mode of operation
Constant surface speed
Tool-tip radius compensation
Turning cycles
Cycle 880: Gear hobbing (option 50 and option 131)
KinematicsComp (option 52)
Three-dimensional compensation
Export license required
Compensation of position and component errors
3D-ToolComp (option 92)
3-D tool radius compensation
depending on the tool’s contact
angle
Export license required
Compensate the deviation of the tool radius depending on the tool’s
contact angle
Compensation values in a separate compensation value table
Prerequisite: Working with surface normal vectors (LN blocks)
Extended Tool Management (option 93)
Extended tool management Python-based
Advanced Spindle Interpolation (option 96)
Interpolating spindle Interpolation turning:
Cycle 291: Interpolation turning, coupling
Cycle 292: Interpolation turning, contour finishing
Spindle Synchronism (option 131)
Spindle synchronization Synchronization of milling spindle and turning spindle
Cycle 880: Gear hobbing (option 50 and option 131)
Remote Desktop Manager (option 133)
Remote operation of external
computer units
Windows on a separate computer unit
Incorporated in the control's interface