HEIDENHAIN TNC 640 - Page 914

Tables and Overviews | Functions of the TNC 640 and the iTNC 530 compared
21
914
HEIDENHAIN | TNC 640 | Conversational Programming User's Manual | 10/2017
Comparison: PC software
Function TNC 640 iTNC 530
M3D Converter for the creation of high-
resolution collision objects for collision
monitoring (DCM)
Available Not available
ConfigDesign for the configuration of
machine parameters
Available Not available
TNCanalyzer for the analysis and evaluation
of service files
Available Not available
Comparison: User functions
Function TNC 640 iTNC 530
Program entry
Klartext X X
DIN/ISO X X
smarT.NC – X
ASCII editor X, directly editable X, editable after
conversion
Position entry
Nominal positions for lines and arcs in Cartesian
coordinates
X X
Nominal positions for lines and arcs in polar
coordinates
X X
Incremental or absolute dimensions X X
Display and entry in mm or inches X X
Set the last tool position as pole (empty CC block) X (error message
if pole transfer is
ambiguous)
X
Surface-normal vectors (LN)
X X
Spline sets (SPL)
– X, with option 9