DR. JOHANNES HEIDENHAIN GmbH
D-8225
Traunreut'Tel.(08669)31-0
Kundendienst
Error messages Twc 151/155
The meanings of many of these error messages are explained in:
- Operating Manual
- Mounting Instructions and Interface Circuit Control-Machine
- PI&Description
KEY NON-FUNCTIONAL
PROGRAM MEMORY EXCEEDED
SEARCH ADDRESS MISSING
TOOL DEF ‘$ NOT PERMITTED
PROGRAM NUMBER ON TAPE ALLOCATED
JUMP TO LABEL 0 NOT PERMITTED
ENTRY VALUE INCORRECT
CC-BLCCK MISSING
CIRCLE END POS. INCORRECT
TOOL DEF MISSING
TOOL CALL MISSING
LABEL NUMBER NC'I' ALLOCATED
EXCESSIVE SUPROGRANMING
ANGLE REFERENCE MISSING
PLANE WRONGLY DEFINED
TOOL RADIUS TOO LARGE
ROUNDING RADIUS Too LARGE
PATH OFFSET WRONGLY STARTED
PATH OFFSET WRONGLY ENDED
ROUNDING-OFF UNDFINED
ROUNDING-OFF NOT PERMITTED
AXIS DOUBLE PROGRAMMED
WRONG RPM
NO EDITING OF RUNNING PGM
RADIUS COMP. UNDEFINED
LIMIT SWITCH X+
LIMIT SWITCH X-
LIMIT SWITCH Y+
LIMIT SWITCH Y-
LIMIT SWITCH AXIS Z+
LIMIT SWITCH AXIS Z-
LIMIT SWITCH AXIS 4+
LIMIT SWITCH AXIS 4-
EXCHANGE BUFFER BATTERY
TRANSFERRED DATA INCORRECT
ME: CASSETTE MISSING
ME: CASSETTE LOClcED
NE: WRONG MODE SELECTED
ME: WRONG PROGRAM DATA
ME: CASSETTE EMPTY
ME: PROGRAM INCOMPLETE
ME: TAPE END
WRONG PROGRAM DATA
MACHINE PARAMETER INCOMPLETE
EXT. IN-/OUTPUT NOT READY
MIRROR IMAGE ON TOOL AXIS
WRONG AXIS PROGRAMMED
WRONG SIGN PROGRAMMED
SPINDEL ROTATES MISSING
SLOT WIDTH TCO LARGE
CYCLE INCOMPLETE
SELECTED BLOCK NOT ADDRESSED
PROGRAM START UNDEFINED
POSITIONING ERROR
EMERGENCY STOP
ARITHMETICAL ERROR
OPERATION PARAMETERS ERASED
3D-INTERPOLATION NOT PERMITTED
SERVICE MANUAL TNC 151/155
Page 7
Section 2.2.2
FURTHER PROGRAM ENTRY IMPOSSIBLE
PROGRAM NUMBER UNAVAILABLE
PROGRAM NUMBER ALLOCATED
LABEL NUMBER ALLOCATED
TOOL NUMBER ALLOCATED
RELAY EXT. DC VOLTAGE MISSING
POWER INTERRUPTED
PGM XXXXXXXX
UNAVAILABLE
TN0 TOOL DEF XXX WITH PGM CALL
CIRCLE CENTP.E UNDEFINED XXXX
ADDRESS LETTER ALREADY ASSIGNED
BLCCKTOO LONG
G-CODE GROUP ALREADY ALICCATED
ILLEGAL G-CODE
BLCCK NUMBER ALREADY ALLOCATED
BLOCK FORMAT INCORRECT
N-CODE MISSING
BLK FORM DEFINITION INCORRECT
PGM-SECTION CANNOT BE SHOWN
TOO MANY USER PARAMETERS
PROTECTED PGM
ILLEGAL NC-BLOCK
CHAMFER NOT ALLOWED
FAULT IN PLC PROGRAM
To Next Page
Loading...
