HEIDENHAIN TNC151B User Manual

HEIDENHAIN
DR. JOHANNES HEIDENHAIN GmbH
D-6225 Traunreut ‘Tel. (08669) 31-O
Kundendienst
Service
Instructions
TNC
x51/155
B/Q
Subject to change (without notice)
DR. JOHANNES HEIDENHAIN GmbH is constantly working on further
developments of its TNC Controls. It is therefore possible
that details of your Control may differ slightly from those
described herein. If that is the case please order a suitably
revised issue of the Service Manual.
Copying/Duplication
This manual is provided subject to the condition that no part
of it shall be reproduced in any form or by any means without
our prior consent in writing.
Issue: 04/88

HEIDENHAIN TNC151B Specifications

General

Control System	CNC
Axes	Up to 3
Input Method	Keyboard
Data Interface	RS-232
Power Supply	24 V DC
Display Size	9-inch
Programming	Conversational Programming
Operating Temperature	0 to 45°C
Humidity	non-condensing
Display	CRT