DR. JOHANNES HEIDENHAN GmbH
D-8225
Traunreut ‘Tel. (08669) 31-O
SERVICE EANUAL TNC 151/155
Page 81
Section 4.4
Kundendienst
Function
“Blockwise Transfer”
ASCII-code data transfer finished
Central tool memory
224
225
Graphic printout 226
Number of control signs to set the printer inter-
face + 1 control sign
Graphic printout 227 0 . . . 65 535
2 control signs to set the printer interface
Graphic printout number of control signs i& front
of every printer line + 1 control sign
Graphic printout
228
229
230
2 control signs in front of every printer line
231
232
233
234
235
Movement supervision
Touch probe: Safety clearance over measuring
point for automatic measuring
Graphic
Representation of graphic in three planes
Rotating the coordinate system of machining plane
Activation and function of spindle axis
Kv-factor for spindle axis 238
Parameter
236
237
Input values
0
-..
12 079
0 -
= no central tool memory
1 . . . 99 G central tool memory with number of tool stores
0 . . . 65 535
0 . . . 65 535
0 . . . 65 535
0.03 . . . 10 [VI
0 . . . 19 999.999 [mm]
0P
t
German standard
no rotation
1 P American standard
2 2 rotation by 90°
Add input values for function requested
0 B Spindle axis not active
1 + Spindle axis serves to orientate the main spindle
without position display
2 2 as input value 1, with position display, however
(is displayed instead of axis IV)
3 P Spindle axis is not controlled: the position display,
however, is active, axis designation A (is displayed
instead of axis IV)
4 ; as input value 3, axis designation B, however)
5 P as input value 3, axis designation C, however)
0.100 . . . 10.000
To Next Page
Loading...
