EASY SETUP
Unpack tent and
accessories
START
Lay out flat on
the ground
LAY OUT
Connect the
pump with adapter
OPEN (x1)
Disconnect the
pump
CLOSE (x1)
Push the clamps to
separate air beams
SECURE (x5)
Apply only slight
pressure
PEG THE
SIDES
Apply moderate
tension to all anchor
points through the
adjusters
TIGHTEN
Apply only slight
pressure
PEG THE
FRONT REAR
Goes really quick
- tent will rise by
itself
INFLATE03 CLOSE (x5)
01 RELEASE THE CLAMPS
02 OPEN ALL VALVES (x5)
03 THEN FOLD BOTH SIDES
across the length towards the center axis. Remember
to remove excess air from the struts by pushing them
after each fold.
THE CAVE DESCRIPTION P.NR.
04 ROLL IT UP TO A SMALL PACKAGE
Start rolling from one end towards the other.
(Roll it one time to remove most of the air. Roll it a
second time to remove the rest of the air.)
05 PUT IT BACK IN THE TENT BAG
Once put in the bag you can further compress the
package.
DISASSEMBLY
To Next Page
Loading...