HeimVision Greets 1 - Wired Installation Procedure

To Next Page

To Previous Page

Step 1:

Connect the U-shape terminals of the

Copper wires with a U-shape Terminal to

the Screw Terminals of the bracket.

Step 2:

Connect and twist wires together as

instructed in the picture.

Step 3:

Use the wire nuts to make sure the strong

connections.

Step 4:

Fix the bracket onto the wall, insert the

doorbell into it, then tighten them

together.

Notes:

• The Voltage of the wires should be 12-24 V.

• If you’ve installed a doorbell before, please use the Copper Wires with 2 U-shape

Terminals to connect Greets 1 with your old doorbells Screw Terminals. Please