MED 1114 2017-12-21
8/40
BETA 200 LED
With these devices, the LED cannot be changed.
BE TA 20 0
• Unscrew the connector (1) and shake lightly to remove the bulb.
• Pull off the bulb cover (2).
• Wipe the glass body of the new replacement bulb with a clean cloth and replace
the bulb cover.
• Insert the bulb into the retinoscope and replace the connector
Service
The device has no components serviceable by the end-user.
General Notes
The warranty for the entire product is invalidated if non-genuine HEINE products
or non-original parts are used and if repairs or modications are made to the
device by persons not authorized by HEINE.
For more information, please visit www.heine.com.
The expected life cycle, when the device is normal used and the warning and
safety information as well as the maintenance instructions are observed, is up
to 7 years. Beyond this period, the product may continue to be used if it is in
a safe and good condition.
Store and use the device in dry and dust-free environments only.
General Warnings
Check the correct operation of the device before use! Do not use the device
if there are visible signs of damage or the light begins to ash.
Do not use the device in re- or explosive risk area (e.g. oxygen saturated or
anesthetic environments)
This product is not allowed to enter or be used in areas with strong magnetic
elds e.g. MRI scanners.
Do not modify the device.
Use only original HEINE parts, spare parts, accessories and power sources.
Repairs shall only be carried out by qualied persons.
Disposal
The product must be recycled as separated electrical and electronic devices.
Please observe the relevant state-specic disposal regulations.
The appendix contains following tables
- Electromagnetic disturbances – Requirements and tests
- Technical specication
- Options
- Explanation of the used symbols
To Next Page
Loading...
Need help?
General
