Location for installing indoor unit
Where there is no obstacle near the air outlet and air can be easily blown to every
corner.
Where piping and wall hole can be easily arranged.
Keep the required space from the unit to the ceiling and wall according to the
installation diagram on previous page.
Where the air filter can be easily removed.
Keep the unit and remote controller 1m or more apart from television, radio etc.
Keep as far as possible from fluorescent lamps.
Do not put anything near the air inlet to obstruct it from air absorption.
Install on a wall that is strong enough to bear the weight of the unit. Install in a
place that will not increase operation noise and vibration. Keep away from direct
sunlight and heating sources. Do not place flammable materials or combustion
apparatuses on top of the unit.
Location for installing outdoor unit
Where it is convenient to install and well ventilated. Avoid installing it where
flammable gas could leak. Keep the required distance apart from the wall.
The pipe length between indoor and outdoor unit should be not more than 5
meters in factory default status, but it can go up to maximum 15 meters with
additional refrigerant charge.
Keep the outdoor unit away from greasy dirt, vulcanization gas exit.
Avoid installing it by the roadside where there is a risk of muddy water.
A fixed base where it is not a subject to increased operation noise.
Where there is not any blockage of the air outlet.
To Next Page
Loading...
Need help?
General
