www.heinner.com 100W, 50Hz, 220-240V
7
1. Why is not the fan
operating
a. The plug inserted may be
lacking electricity or fuses may
have gone off.
b. PCB is damaged.
a. Make sure the plug works and check your
fuses.
b. Change the same type of PCB
a. The rear guard is not
installed tightly.
b. The blade can is loosened.
c. The blade is damaged.
d. the blade is imbalance.
a. Install the rear guard tightly.
b. Tighten the blade cap.
c. Change a new fan blade.
d. Turn the fan blade 180°and then
installation again.
3. The mist projector
is working properly
but there is not mist
spray.
a. Perfume or chemical
material may have been added.
b. Water tank is broken or
cracked or the flume is full of
water.
a. Clean the water tank, atomizing cup and
flume.
b. Put out the water from flume, change a
new water tank.
4. Why doesn’t the
mist projector work?
a. Pull out the bobber and let it float out.
5. Why is there no
indicator light on, no
mist and no wind?
a. Power cord is not connected
properly and electric power is
off
a. Ensure that the power cord plug is fully
inserted into the electrical outlet and turn on
the electric power.
6. Why is there no
mist even though the
indicator light is on
and has wind?
a. No water in tank.
b. Water switch is off.
c. Water level bobber is not
pressed out.
a. Add water.
b. Turn on the water switch.
c. Press out the bobber.
7. Why is there a
peculiar smell of mist?
a. Peculiar mist will disappear
after some time.
b. Water tank is dirty.
a. Take out the tank, and out it to a ventilated
add dry place.
b. Change fresh water.
8. Other unusual
problems
a. Motor gave out smoke or
feeling a smell of burn.
b. Metal parts exposed with
electric or the fan insulation is
damaged.
c. The rear cover of motor is
damaged.
a.b.c. Stop using and send your appliance to
technical service for maintenance
VIII. TROUBLESHOOTING GUIDE
To Next Page
Loading...
Need help?
General
