6. INSTALLATION
Installation area
• Stability is important to prevent the product from wandering!
•Make sure that the product should not stand on the power cord.
•Before installing the machine, the location characterized as follows shall be selected:
1.Rigid, dry, and level surface
2.Avoid direct sunlight
3.Sufficient ventilation
4.Room temperature is above 0℃
5.Keep far away from the heat resources such as coal or gas.
Unpacking the washing machine
• Packaging material (e.g. Films, Styrofoam) can be dangerous for children.
•There is a risk of suffocation!
•Keep all packaging well away from children.
1. Remove the cardboard box and styrofoam packing.
2. Lift the washing machine and remove the base packing. Make sure the small triangle foam is removed
with the bottom one together. If not, lay the unit down with side surface, then remove the small foam from
the unit bottom manually.
3. Remove the tape securing the power supply cord and drain hose.
4. Remove the inlet hose from the drum. Make sure the small triangle.
To Next Page
Loading...
Need help?
General
