Remove transport bolts.
• You must remove the transport bolts from the backside before using the product.
• You’ll need the transport belts again if you move the, so make sure keep them in a safe place.
Please take the following steps to remove the bolts:
1.Loosen 4 bolts with spanner and then remove them.
2.Stop the holes with transport hole plugs.
3.Keep the transport bolts properly for future use.
Levelling the washing machine
• The lock nuts on all four feet must be screwed tightly against the housing
1. Loosen the lock nut.
2. Turn your foot until it reaches the floor.
3. Adjust the legs and lock the nuts with a spanner. Make sure the machine is level and steady.
Connect the water supply hose!
To prevent leakage or water damage, follow the instructions.
• Do not kink, crush or modify water inlet hose.
• Connect manually, do not use tools. Check if the connections are tight.
To Next Page
Loading...
Need help?
General
