4
necessary.
(13) Tilt the mast of the high lift forklift truck as backward as possible while the truck
working. Use minimum forward tilt angle and Min. reverse tilt when loading and
unloading.
(14) Be careful and slowly driving over a dockboard or bridge-plate.
(15) Shut down the truck and don’t stay on the truck when checking battery or fuel
lever.
(16) The unloaded forklift truck with attachments should be operated as a loaded
truck.
(17) Don’t handle unfixed stacked goods. Be careful to bulky goods to be handled.
(18) If leaving the truck, lower the forks on the ground and let the shift lever to
neutral, shut down the engine or cut down electric supply. If parking on a slope is
unavoidable, apply the parking brake and block the wheels.
(19) Don’t adjust the control valve and relief valve at will to prevent the damage of
hydraulic system and its components because of excessive pressure passing them.
(20) Inflate a tyre according to it’s stated air pressure. Never over inflate a tyre.
(21) According to the measure method specified in JB/T 3300, the max. noise at the
outboard of the truck should be not more than 80dB(A).
(22) Be familiar with and pay attention to the functions of the decals on the forklift
trucks.
5. Application environment
1) Environment temperature: -25ºC ~ +40ºC；
2) Relative humidity: <90%；
3) Altitude: <1200m.
6. Daily Maintenance of Forklift Trucks
(1) Inspection before startup
a) Hydraulic oil volume: oil level should stay in the middle of oil meter scale;
To Next Page
Loading...
Need help?
General
