Need help?Do you have a question about the HELIX B Four and is the answer not in the manual?
General| Channels | 4 |
|---|---|
| Signal-to-Noise Ratio | > 100 dB |
| Damping Factor | > 100 |
| Frequency Response | 10 Hz |
| Input Impedance | 10 kOhms |
| Input Sensitivity | 0.5 - 6 Volts |
| Fuse | 2 x |
Install amplifier in a dry, well-ventilated area, secured professionally with four screws, checking for hidden cables/lines.
Ensure 12V negative chassis ground, use a main fuse near battery, route cables safely, protect from sharp edges, avoid power cable proximity to other equipment.
Indicates amplifier operational status: green for ready, red for malfunction or protection activation.
Connect to a central ground point on the vehicle chassis, ensuring a clean metal surface and minimum 12 mm² cross-section.
Connect to the head unit's automatic antenna output for amplifier power control linked to the radio.
Connect the +12V cable to the battery's positive terminal with a minimum 12 mm² cross-section.
Internal fuses protect against faults; system requires an additional external fuse near the battery (2 x 25A recommended).
Connect speaker cables to the terminals, ensuring correct polarity and an impedance not lower than 2 Ohms per channel.
Four RCA inputs for pre-amplifier outputs; all must be connected for four-channel operation; Y-adapter usable for two outputs.
Four inputs connect directly to head unit speaker outputs, featuring an automatic turn-on function.
Adjust input sensitivity to match head unit output voltage; control range is 200 mV to 6 V.
Adjustable bass boost from 0 to 18 dB at 45 Hz.
Adjusts the crossover frequency for the highpass filter from 15 Hz to 4000 Hz.
Selects internal crossover mode: Highpass (HPF), Fullrange (FULL), or Lowpass/Bandpass (LPF).
Adjusts the crossover frequency for the lowpass filter from 40 Hz to 4000 Hz.
Wide band (fullrange) RCA outputs for connecting additional amplifiers.
Diagrams illustrating 4-channel, 3-channel, and 2-channel (bridged) speaker connection configurations.
Warranty covers legal regulations; excludes overload, improper use, or physical damage. Requires proof of purchase for claims.
No liability assumed for damages to vehicle or device caused by user error or improper handling.
Amplifiers feature E-Certification and CE-Mark, certifying them for use within the European Union (EU).
To Next Page
