Need help?Do you have a question about the HELIX P ONE MK2 and is the answer not in the manual?
General| Frequency Response | 10 Hz - 250 Hz |
|---|---|
| Phase | 0 - 180° |
| Signal-to-Noise Ratio | >95 dB |
| THD | <0.1 % |
| Damping Factor | > 200 |
| Idle Current | 1.8 A |
| RMS Power @ 2 Ohms | 1000 Watts |
| RMS Power @ 1 Ohm | 1600 Watts |
| Bass Boost | 0 - 12 dB |
| Lowpass | 50 Hz - 250 Hz |
| Subsonic | 10 - 50 Hz |
| Input Impedance | 10 kOhms |
| Fuse | 2 x 40 A |
| Type | Monoblock Class D Amplifier |
| Crossover | Lowpass and Subsonic |
Provides instructions for safe installation to prevent unit damage and injury.
Details requirements for 12V negative ground systems and fuse/cable specifications.
Adjusts input sensitivity to match the signal source, not a volume control.
Details connecting power (+12V), ground (GND), and remote (REM) inputs.
How to properly set input sensitivity using the gain control and Clipping LED.
Connects speakers to outputs, ensuring correct polarity and impedance (min 1 Ohm).
Provides specific settings for left and right amplifiers in a stereo digital setup.
To Next Page
